Charging The Batteries - Datalogic QuickScan QM2400 Quick Reference Manual

Charging the Batteries

Charging the Batteries
To charge the battery, simply insert the QuickScan reader into
the base. When the scanner is fully seated in the cradle, it will
sound a "chirp" to indicate that the cradle has detected the
scanner connection.
The LEDs on the base (shown in
cate the status of the battery.
Before using the battery, read "Battery Safety" in
the Regulatory Addendum for this manual. Data-
logic
rechargeable battery packs to ensure maximum
NOTE
performance.
Alternatively, the battery can be charged by connecting the
reader directly to a host through the micro-USB connector
available in the bottom of the handle, as shown below.
8
recommends
Table 1 on page
annual replacement
7) will indi-
Micro-USB
Connector
QuickScan™ QM2400
of