Programming Mode - Datalogic QuickScan QM2400 Quick Reference Manual

LED and Beeper Indications
Indication
Reader
Disabled
a
Green Spot
flashes momen-
tarily
a Except when in sleep mode or when a Good Read LED Duration other than
00 is selected

Programming Mode

the reader is in Programming Mode.
Indication
Label Programming
Mode Entry
Label Programming
Mode Rejection of Label
Label Programming
Mode Acceptance of Par-
tial Label
Label Programming
Mode Acceptance of Pro-
gramming
Label Programming
Mode Cancel Item Entry
34
Description
The reader has been dis-
abled by the host.
Upon successful read of a
label, the software shall
turn the green spot on
for the time specified by
the configured value.
- The following indications ONLY occur when
Description
A valid programming
label has been scanned.
A label has been rejected.
In cases where multiple
labels must be scanned to
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully scanned.
Configuration option(s)
have been successfully
programmed via labels
and the reader has exited
Programming Mode.
Cancel label has been
scanned.
LED
The LED blinks continu-
ously
N/A
LED
LED blinks con-
tinuously
N/A
N/A
N/A
N/A
Beeper
N/A
N/A
Beeper
Reader sounds four
low frequency beeps.
Reader sounds three
times at lowest fre-
quency and current
volume.
Reader sounds one
short beep at highest
frequency and current
volume.
Reader sounds one
high frequency beep
and 4 low frequency
beeps followed by
reset beeps.
Reader sounds two
times at low fre-
quency and current
volume.
QuickScan™ QM2400