Maintenance Before Every Use - Eastman Outdoors Revolution 37059 Instruction And Safety Manual

Fig. 20
Open LP tank valve one turn by slowly turning it counter clockwise. If you hear gas rushing, smell gas,
or see growing bubbles, immediately turn LP tank off. Check to make sure regulator control valve is
closed and connections are tight.
Retest system. If you still hear gas rushing, smell gas, or see growing bubbles, immediately turn LP
tank off and contact Eastman Outdoors Customer Service Department at 1-800-241-4833. DO NOT
USE THE BURNER.
Turn regulator control valve ¼ turn clockwise to open valve. If you hear gas rushing, smell gas or see
growing bubbles on the timer shutoff, immediately turn LP tank off and contact Eastman Outdoors
Customer Service Department at 1-800-241-4833. DO NOT USE THE BURNER.
If you do not hear or smell gas or see growing bubbles turn the timer knob to start timer on the timer
shutoff. This allows gas to pass through the hose and to the burner. After 5 seconds close the
regulator control valve. Do not leave regulator control valve open for more than 5 seconds. Check
to ensure there are no leaks at the connections, hose crimps, or entire length of hose where soapy
water has been applied. If growing bubbles begin to appear, there is a leak. Immediately turn off both
the LP tank valve and regulator control valve.
Tighten the connections and repeat test. If the leak cannot be stopped, contact Eastman Outdoors
Customer Service Department at 1-800-241-4833. DO NOT USE THE BURNER.
Always close the regulator control valve and LP tank valve after performing the leak test.
STEP 2 OPERATION
Step 2.1 Maintenance Before every use
Before each use, check to make sure appliance area is clear and free from combustible materials,
gasoline and other flammable vapors and liquid.
Perform leak test on all gas connections, hose, regulator control valve, timer shutoff, and QCC1. If
bubbles form in leak test solution, do not use.
Clean and inspect hose before each use. If there is evidence of abrasion, wear, cuts or leaks, the
hose must be replaced prior to using the appliance.
supplied must be used.
Before each use, visually check the ventilation opening(s) of the LP tank enclosure and the burner
to ensure they are free and clear of debris. Do NOT obstruct flow of combustion and ventilation air.
Keep the ventilation opening(s) of the cylinder enclosure and burner free and clear of debris.
Before each use, visually check and clean burner, venturi, and orifices for insects and insect nests.
Spiders and small insects can nest in venturi or orifices during warehousing, transit, or between
periods of use. Obstructions in the venturi or orifices interfere with the flow of air and gas through
the burner. This can cause a yellow flame, flashback, and lead to a fire beneath the burner. If this
occurs, immediately turn LP tank valve off and turn regulator control valve off. DO NOT USE
BURNER. If a nest is detected, with burner at room temperature, clean venturi and casting holes
with a bent wire, pipe cleaner, or screwdriver. Compressed air may help clear away small particles.
Before and after each use, with the gas OFF at the LP tank and the burner cooled to room
temperature, visually check the regulator control valve, timer shutoff, QCC1, hose, hose
connections, burner parts, air shutter, and venturi section for any sign of wear or damage.
OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Fig. 21
Replace only with Eastman Outdoors Model No. S90099.
Fig. 22
The high pressure regulator hose assembly
Page 8 of 19