Clean Up; Packing And Storage; Frequently Asked Questions - Eastman Outdoors Revolution 37059 Instruction And Safety Manual

Table of Contents

Advertisement

IMPORTANT NOTE: The timer shutoff may have to be reset in order to maintain cooking temperature.
Always reset the timer shutoff before the timer reaches the one minute mark. If the time expires on the
timer shutoff and flame is extinguished, turn the regulator control valve to the off position and relight the
burner by following the lighting instructions in this manual.
Once food is completely cooked, turn burner off by first turning regulator control valve off and then turn
LP tank valve off. Follow included cooking instructions on how to remove food from cooking vessel.
Step 4 Clean Up
Allow burner, cooking vessel, and contents to cool to room temperature
before cleaning.
Once at room temperature, remove oil/grease or water from cooking vessel. Store used oil according to
oil manufacturer's recommendations or dispose of properly. Do not pour oil/grease down any drain in
your dwellings. Do not pour oil/grease or salt water onto yard or lawn.
Clean cooking vessel with degreasing dish soap and hot water. Dry to prevent water spots. Do not use
soap-filled steel wool pads, abrasive sponges, or abrasive cleaners because scratching can occur.
Clean burner, as needed, with degreasing dish soap and water. Avoid getting water in burner casting.
Once clean, coat burner legs and burner body with a light layer of cooking oil. Avoid getting cooking oil
in burner casting. If rusting occurs, use steel wool to clean or buff rusted area and coat with cooking oil.
Do not paint interior of appliance. The exterior of the appliance may be touched up by using high
temperature paint.
Step 5 Packing and Storage
Allow burner, cooking vessel, and contents to cool to room temperature before
touching burner or locking knobs.
Step 5.1 Burner and LP tank storage
Close regulator and LP tank valves when not in
use. Disconnect LP tank and hook hose end with
QCC1 fitting onto orifice assembly (figure 35) to
protect the fitting from being damaged.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or
plugs may result in leakage of propane.
LP tank must be stored in an upright position outdoors, out of the reach of children and must not be
stored in a building, garage, or any other enclosed area.
Read and follow all instructions and storage instructions on LP tank.
Storage of appliance indoors is permissible only if LP tank is disconnected and removed from
appliance.
Store burner in a protected cool dry area and cover it to help prevent spiders and insects from
nesting in the venturi and orifices.
Step 6 Frequently Asked Questions
Flame burns yellow, blows out, does not burn at all, or there is a flame inside the venturi?
Immediately turn gas OFF at LP tank. Spiders and insects can build nests inside burner venturi
blocking air and gas flow. If this occurs, with gas OFF at LP tank and burner at room temperature,
remove air shutter, spring, and hose assembly. Clean venturi tube and casting holes with a bent wire,
OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Fig. 35
Page 13 of 19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Revolution 38024Revolution 37068Revolution 37069

Table of Contents