Shut Off; Using Your Appliance - Eastman Outdoors Revolution 37059 Instruction And Safety Manual

Turn off regulator control valve by turning valve counter clockwise until tight. Start propane gas flow
from LP tank by slowly turning the LP valve two complete turns counter-clockwise.
Turn timer knob clockwise to desired time setting
(figure 26) on the timer shutoff. If desired time
setting is greater than maximum setting on timer,
one must reset timer before timer reaches the 1
minute mark.
Place a lit match (Eastman Outdoors strongly
recommends using a long-stem match or lighter)
under the burner up through the hole in the center
of the burner element (figure 27).
Slowly turn the regulator control valve a half rotation (counter-clockwise) until burner lights. Do not open
regulator control valve more than 1/2 a turn until the burner is lit.
If burner does not ignite in 3 to 5 seconds, turn regulator control valve off and turn LP tank valve off.
Check to make sure the LP tank is not empty. Wait five minutes for gas fumes to dissipate. Do not
attempt to re-light if you smell gas. Disconnect the QCC1 fitting and reconnect it to LP tank. Doing this
resets the safety valve in the LP tank if the valves are opened too quickly. Repeat the lighting
procedure making sure to open both valves slowly.
When burner is lit, turn regulator control valve to
regulate flame intensity. Turn valve counter-
clockwise to increase flame. Turn valve clockwise
to reduce flame. Flame should be deep blue to
almost invisible in light (figure 28). If not, adjust air
shutter until a blue flame is obtained (figure 29).
If flame goes out during operation or the time expires on the timer shutoff extinguishing the flame, first
turn regulator valve off and then turn LP tank valve off. Wait five minutes for gas fumes to dissipate and
then repeat lighting procedures.
Step 2.2 Shut Off
Shut off the regulator control valve by turning it clockwise until tight.
When the flame is out, close the LP tank by turning the tank valve clockwise until tight.
If the appliance is not in use, gas must be turned off at the LP tank.
Burner, pot, and contents must be allowed to cool to room temperature before handling.
When the burner is not in use, disconnect the regulator and hose from LP tank and hook it onto the
hose connection to protect the QCC1 fitting from being damaged.
STEP 3 Using Your Appliance
Before first use, wash cooking vessel in hot soapy water. Dry to prevent water spots. To prevent
scratches, avoid using sharp utensils when cooking and avoid soap-filled steel wool pads, abrasive
sponges, or abrasive cleaners when cleaning. Discoloration of pot may result if pot is allowed to
overheat.
OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Fig. 26
Fig. 27
Fig. 28 Fig. 29
Page 10 of 19