MOTO GUZZI V1000 G5 Owner's Manual page 35

• undo nut ,,6», drive box side ;
• undo screw securing spindle "C " to the rear
fork arm;
• withdraw spindle "D " from drive box . brake
hob, swing arm;
• withdraw braking disc from caliper "E ,, ;
• after disconnecting the parking brake control
cable , slip off the plate complete with hydraulic
and mechanical calipers. Do not disconnect the
hydraulic duct;
• lean the vehicle to the right so as to allow
wheel "F» to be slipped off from the rear fork
arm and the drive bo x.
When re-fitting, proceed in reverse sequence,
making sure to insert the plate complete with ca -
lipers in the rear fork lug and to hook the park-
ing brake cable to its operating rod .
Adjusting the spokes
Check that all spokes are tight and trueness of
the wheel as follows :
• I"",
the wheel and check its truing using a
33
suitable gauge. If necessary adjust the right or
left spokes until the wheel turns properly. This
check has to be done after the first 500 km (300
miies) and then every 1500 km (900 miles) .