MOTO GUZZI V1000 G5 Owner's Manual page 31

the other end of the duct plunged Into a tran -
sparent container «H» partially filled up with li-
quid of the same type.
2 Loosen drain plug «E».
3 Completely actuate brake control lever «S»
several times, releasing it slowly and waiting a
few minutes before pulling it again.
Repeat the operation until the duct end plunged
into the transparent container emits airless fluid.
4 Keep control lever «S» fully pulled and lock
drain plug «E». Then take out plastic duct «G»
and re-fit the rubber cover on the drain plug.
If the air bleeding has been carried out correc-
tly, a direct and efficient working of the fluid will
be perceived immediately after the initial idle mo-
vement of lever «S».
If not, repeat the operation.
Front left and rear braking
circuit
(fig . 17)
Follow the same procedure as described in chap-
brake fluid in the braking circuits". except point
29
«1» and in «Sraking circuit for the right front
brake» except points «3» and «4».
Level
It is indicated by warning light «S», fig. 4 on
the panel. When it lights up it is necessary to
top up.
Bleeding
3 Press down completely control pedal «S». etc.
4 Keep the pedal pressed down. etc.
ter «Checking the fluid level and replacing the
18 . . . . . . _ _ _
!!!!!_~~.