Acer Altos R360 F2 Frequently Asked Questions Manual page 12

Altos R360 F2 FAQ (Frequently Asked Questions)
For connection mode:
Concurrent (Default): : : : All of onboard LAN port 1, onboard LAN port 2 and optional dedicated server Concurrent (Default) Concurrent (Default) Concurrent (Default)
•
management port can be used for management with different IP address. All NIC ports must be on
different subnet.
Failover Failover: : : : All of onboard LAN port 1, onboard LAN port 2 and optional dedicated server management port Failover Failover
•
are bonded together. The setting of onboard LAN port 1 will be used for bonding. If a connection fails,
Smart Console connection will switch to the others. Failover mode can be enabled in Smart Console.
8. How do I configure the IP address of BMC on Altos R360 F2?
ANSWER: ANS ANS ANS WER: WER: Please enter BIOS Setup during POST. WER:
a. Please select Server Management.
b. Please select BMC LAN Configuration.
c. You would see information below.
Baseboard LAN configuration
IP Source
IP Address
IP Subnet Mask
Gateway IP
Intel (R) RMM4 LAN Configuration
Intel (R) RMM4
IP Source
IP Address
IP Subnet Mask
Gateway IP
d. Please specify IP address, IP Subnet Mask, and Default Gateway under Baseboard LAN configuration
for share NIC of onboard LAN port 1.
e. If Altos R360 F2 is installed with Dedicated Management Port, please specify IP address, IP Subnet
Mask, and Default Gateway under Intel (R) RMM4 LAN configuration
f. Please save the settings and exit from BIOS Setup.
9. Can Altos R360 F2 BMC use the same IP address as the one in operating system?
ANSWER: No. Please do not use the same IP address for BMC and operating system. ANSWER:
ANSWER: ANSWER:
10. Should I unplug the power cord of Altos R360 F2 after I update the BMC firmware or SDR?
ANSWER: ANSWER: You do not need to unplug the power cord of Altos R360 F2 after updating the BMC firmware. ANSWER: ANSWER:
Since the BMC will continue to operate even though the system is powered off. So, please reboot the system
so that the BMC is reset to reload the BMC firmware or FRUSDR.
[Static]
010.036.060.100
255.255.255.000
010.036.060.001
Intel (R) RMM4+DMN
[Static]
010.036.061.100
255.255.255.000
010.036.061.001
12