Acer Altos R360 F2 Frequently Asked Questions Manual page 59

Altos R360 F2 FAQ (Frequently Asked Questions)
PCU SLOT ID
-------- --
1
0 Virtual Drive(s) Found on the host adapter.
0 Virtual Drive(s) handled by BIOS
Press <Ctrl><H>
7. How do I configure MegaRAID in EFI mode?
ANSWER: Please enter EFI Shell during POST ANSWER: ANSWER: ANSWER:
a. In EFI Shell, please type in below command.
drvcfg -s
b. You will see below options.
Press 1 for EFI WebBIOS
2 for EFI CLI
or any other key to return:
c. Please select 1 for EFI WebBIOS
8. Is there any step-by-step procedure to create RAID with MegaRAID?
ANSWER: Please refer to Appendix E of Altos R360 F2 ICG (Installation Configuration Guide). ANSWER: ANSWER: ANSWER:
9. What RAID utility does MegaRAID support?
ANSWER: MegaRAID Storage Manager for Windows & Linux. ANSWER:
ANSWER: ANSWER:
10. Where can I find the RAID utility of MegaRAIDi?
ANSWER: ANSWER: The RAID utility can be found in Smart Setup DVD. ANSWER: ANSWER:
11. Can I install both SAS and SATA HDD on Altos R360 F2 with MegaRAID?
ANSWER: Yes, but please create separated RAID volumes with SAS and SATA HDD, respectively. ANSWER:
ANSWER: ANSWER:
For example, you may create 2 x SATA HDD as RAID 1, another 2 x SAS HDD as RAID 1.
But, please don't create a RAID volume with mix of SATA and SAS HDD.
12. How do I create RAID 10 with MegaRAID?
ANSWER: For configuring RAID 10, you need 4 HDDs in the system. ANSWER:
ANSWER: ANSWER:
Please follow below procedures below.
a. To start the RAID BIOS utility, please press CTRL-H during POST
b. After POST finished, the Adapter Selection page will display on the screen. Click on Start
configuration menu
c. Please select Adapter Properties to set Factory Defaults from No to Yes, and then click on submit.
d. Reboot the server and then enter the RAID BIOS utility again by pressing CTRL-H during POST
e. Launch the configuration menu.
f. Select Configuration Wizard Configuration Wizard
Configuration Wizard Configuration Wizard
g. Select Add Configuration Add Configuration (default) and click on Next Add Configuration Add Configuration
h. Select Manual Manual Configuration Manual Manual
LUN VENDOR PRODUCT
--- ------- -------
LSI LSI MegaRAID SAS MR9240-4i
for WebBIOS or press <Ctrl><Y> for Preboot CLI
Configuration (default) and click on Next Configuration Configuration
REVSION
-------
Next. Next Next
Next. Next Next
59
CAPACITY
--------
0MB
Start to launch the
Start Start