Remote Control - Pioneer SC-LX88 Operating Instructions Manual

13
Symptom Remedy
When playing Dolby Digital or DTS Check that the player is connected using a digital connection.
sources, the receiver's format indica-
Make sure that the receiver is set to AUTO or DIGITAL (see
tors do not light.
page 66 ).
Check that the player isn't set up so that Dolby Digital and DTS sources are converted to
PCM.
Ensure that if there are several audio tracks on the disc, the Dolby Digital or DTS is
selected.
When playing certain discs, none of The disc may not contain multi-channel material. Check the disc packaging for more on
the receiver's format indicators light. what audio tracks are recorded on the disc.
It does not light when the PCM signal or analog signal is input.
When playing a disc with the listen- Make sure that the receiver is set to AUTO or DIGITAL (see
ing mode set to Auto Surround or page 66 ).
ALC, DTS Neo:X does not appear on
If a two channel soundtrack is currently playing (including Dolby: 2.0 Surround), then
the receiver.
this is not a malfunction. Check the disc packaging for details about the audio tracks
available.
During playback of DVD-Audio, the This will occur when playing DVD-Audio material over the HDMI connection. This is not
display shows PCM. a malfunction.
The power turns off automatically See the Power section
and some indicator flashes, or some
indicator flashes and the power does
not turn on.
Track names, etc., are not displayed The OSD Language setting must be switched to Chinese. For details, see
in Chinese on the OSD when playing OSD display language (OSD Language)
with the network function, a USB
input, etc.
Choosing the input signal
Choosing the input signal
(page 114 ).
Changing the
on page 54 .

Remote control

Symptom Remedy
on
Cannot be remote controlled. Set the remote control unit's remote control mode so that it matches the setting on the
main unit (see
Check whether the receiver's remote control mode is properly set (see
Mode Setup
Try replacing the batteries in the remote control (see
Be sure to operate within 7 m and a 30º angle of the remote sensor on the front panel
(see Operating range of remote control unit
Check that there are no obstacles between the receiver and the remote control.
on
Make sure that there is no fluorescent or other strong light shining on to the remote
sensor.
Other components can't be operated If the battery ran down, the preset codes may have been cleared. Re-enter the preset
with the system remote. codes.
The preset code may be incorrect. Redo the procedure for entering preset codes.
When commands from the remote control units of other devices are registered using the
learning function, in some cases they may not be learned properly. In this case, register
the commands again using the learning function (see
they may be in a special format that cannot be registered on this receiver's remote con-
trol. Operate the device using another remote control.
118
Operating multiple receivers on page 89 ).
on page 108 ).
Loading the batteries
on page 11 ).
page 90 ). If they still do not work,
FAQ

Remote Control

on page 10 ).