Philips 200WB7EB/27 Service Manual page 4

4
200WB7 LCD
Front View
To switch monitor's power On and Off
1
2
To access OSD menu
3
To adjust the OSD
4
To adjust brightness of the display
To adjust the OSD
5
Automatically adjust the horizontal position,
6 AUTO
vertical position, phase and clock setting
Rear View
1 AC power input
2 DVI-I input
3 VGA input
4 Kensington anti-thief lock
5 USB upstream
Installation
Accessory Pack
Item
Connecting to Your PC
Connect the power cord and DVI cable to the back of the monitor
firmly. (Philips has pre-connected VGA cable for the first
installation.)
Notes:If you use an Apple Macintosh , you need to connect the
special Mac adapter to one end of the monitor signal cable.
Connect the cables to the back of your computer by following these
steps:
(a) Turn off your computer and unplug its power cord.
(b) Connect the monitor signal cable to the video connector on the
back of your computer.
(c) Plug the power cord on your computer and your monitor into a
nearby outlet.
(d) USB plug
(1) Connect USB upstream port on monitor and the USB port on
PC with a USB cable.
(2) The USB downstream port is now ready for any USB device to
plug in.
(e) Turn on your computer and monitor. If the monitor displays an
image, installation is complete.
Note: The USB plug is a pass through connection whether it can
support USB 1.1 or USB 2.0 depends on your PC's specification.
Description
Power cord
VGA signal cable
DVI-D cable
USB cable
EDFU pack
TM