Table of Contents
Advertisement
Specifying the Controller Sleep State Trigger Time (Sleep)
Procedure
* MENU * Setup * Sleep
Use this function to specify how much time should be allowed to laps until the
controller display goes blank and the controller enters the sleep state. You can
specify either 30 seconds (30 sec) or 10 minutes (10 min).
Formatting Built-in Memory or a Memory Card (Format)
Procedure
* MENU * Setup * Format
If a memory card is loaded in the camera, this operation will format the memory card.
It will format built-in memory if no memory card is loaded.
• The format operation will delete all contents on the memory card or in built-in
memory. It cannot be undone. Make sure you do not need any data currently on
the card or in built-in memory before you format it.
• Formatting built-in memory or a memory card will delete all protected images
stored there.
• Check the battery level before starting a format operation and make sure it is not
too low. Formatting may not be performed correctly and the camera may stop
operating normally if the camera powers down while formatting is in progress.
71
Other Settings (Set Up)
Advertisement
Table of Contents
