Commodore 64C Introductory Manual page 31

loading cartridge software
CAUTION-YOU MUST TURN
OFF YOUR COMMODORE 64C
COMPUTER BEFORE YOU INSERT
OR REMOVE CARTRIDGES. IF
YOU DON'T, YOU MAY DAMAGE
THE CARTRIDGE AND THE
COMPUTER.
Follow these steps to load cartridge
software:
1. TURN OFF THE COMPUTER.
Press the ON/OFF switch on the right
side of the computer. The screen display
on your monitor or television set should
go dark.
2. INSERT THE CARTRIDGE IN
THE CARTRIDGE PORT.
The cartridge port is the first port on the
right side of the back of the Commodore
64C. This port accepts a cartridge only
one way—with the title up. Insert the
cartridge firmly but do not force it.
3. TURN ON YOUR COMMO
DORE 64C.
That's all there is to it. Your cartridge will
load automatically at this point. You do
not have to use a LOAD command, and
usually you do not need to use a RUN
command. To use the program, just fol
low the directions given on the screen, or
in any printed instructions that come
with the cartridge.
27