Brakes; Battery Safety - Excel Entice 4 User Manual

User Manual
Driving off thresholds: drive to the threshold until the front wheel is before it. Drive off the threshold carefully
and with low speed. Please always make sure that the anti-tip device never interferes with a threshold or kerb
when mounting or dismounting.

Brakes

Braking can be done in different ways:
• you can slowly move the gas lever into the neutral position, to make the Entice slow down easily
• you can just let the gas lever go, so the Entice will come to a full stop
• the Entice is also fitted with a disk brake rear with the lever on the tiller. This may be used on eventual
emergency stops
If driving down a hill the Entice might drive faster than the maximum speed possible. In this case the control unit
will slow the Entice down to reach the programmed maximum speed.
If the gas lever of the Entice is in neutral position the scooter is braked. The motor brake power is enough to stop
the scooter and keep on its place on the maximum possible incline angle (12 degrees).
At rain, snow or other slippery road conditions, please brake gently to provide sliding danger.

Battery safety

When driving on low or empty batteries, to be seen on your battery indicator, the battery safety feature will be
engaged. This provides battery damage through deep discharge. The engagement of this feature can be noticed
by the decreasing maximum speed. Drive as little as possible in this condition. After thy system being engaged
the batteries should be charged as soon as possible.
Freewheel
The Entice is equipped with a so-called freewheel function. This allows the Entice to be moved without using the
engine. Push the backrest to move the scooter. In this freewheel position the scooter can not be driven
electrically. You can engage the freewheel function by the freewheel lever on the rear side of the scooter, just
below the cover (picture 35).
Picture 35
It is important to first fully turn off the power before engaging the freewheel lever. The power needed to push the
scooter is minimal. The brakes of the Entice are not in use during freewheel engagement. This can be reversed
by turning the freewheel function off.
Fault by engaged freewheel
If the Entice is powered when you engage the freewheel lever, the status indicator will indicate fault code 5. To
erase the fault code and drive electrically please proceed as follows:
• first disengage the freewheel function (push the freewheel lever down)
• then, power off the system (this erases the fault)
• when the system is powered up the scooter is able to drive again
The Entice chair
The chair of the Entice is equipped with a number of adjustment possibilities which improves your seat and
driving comfort considerably. The entire chair can be height adjusted in a range of 10 cm in 4 steps of 2,5 cm.
This adjustment can be done by your dealer.
Excel Entice
Pagina 11