Disassembly Procedure - Mitsubishi Electric SLZ-KF25VA2 Technical & Service Manual

10

DISASSEMBLY PROCEDURE

SLZ-KF25VA2.TH
SLZ-KF25VA2.TH-ER
OPERATING PROCEDURE
1. Removing the air intake grille and air filter
(1) Slide the knob of air intake grille to the direction of the arrow
1 to open the air intake grille.
(2) Remove the grille hook from the panel to prevent the grille
from dropping.
(3) Slide the hinge of the intake grille to the direction of the
arrow 2 and remove the air filter.
2. Removing the panel
(1) Remove the air intake grille. (Refer to procedure 1)
Connector box (See Photo 1)
(2) Remove the screw of the connector cover.
(3) Slide the connector cover to the direction of the arrow to
open the cover.
(4) Disconnect all the connectors, then pull out the connectors
that are coming from panel side from the connector box.
Corner panel (See Figure 2 and Photo 2)
(5) Loosen the screw from the corner of the corner panel.
(6) Slide the corner panel as indicated by the arrow.
(7) Remove the safety strap from the hook, then remove the cor-
ner panel from the panel.
(The safety strap is not equipped for the signal receiver panel
and i-See sensor corner panel.)
(8) Remove the fastener (*), then remove the corner panel.
Panel (See Photo 3)
(9) Remove the 4 screws.
(10) Unlatch the 2 hooks.
* Fastener is only for the signal receiver and i-See sensor corner panel.
OCH616
SLZ-KF35VA2.TH
SLZ-KF35VA2.TH-ER
SLZ-KF50VA2.TH
SLZ-KF50VA2.TH-ER
Be careful when removing heavy parts.
PHOTOS & ILLUSTRATIONS
Figure 1
Air intake grille
1
1
Grille
Air intake grille knobs
Photo 1
Connector
box
Fastener*
Connector cover
Figure 2
Screw
Corner panel
Photo 2
Safety strap
Photo 3
Hook
30
SLZ-KF60VA2.TH
SLZ-KF60VA2.TH-ER
Grille hook
Air filter
2
Screw
Fastener*
Grille
Hook
Screws
Turbo fan
Nut and
washer for
turbo fan
Hook
Screws