Craftsman 315.212350 Operator's Manual page 29

CUTTING CROWN MOLDING
The compound miter saw does an excellent job of cut-
ting crown molding. In general, compound miter saws do
a better job of cutting crown molding than any other tool
made.
In order to fit properly, crown molding must be compound
mitered with extreme accuracy.
The two contact surfaces on a piece of crown molding
that fit flat against the ceiling and the wall of a room are at
angles that, when added together, equal exactly 90
crown molding has a top rear angle (the section that fits
flat against the ceiling) of 52
section that fits flat against the wall) of 38
LAYING MOLDING FLAT ON THE MITER
TABLE
See Figure 39.
To use this method for accurately cutting crown molding
for a 90 inside or outside corner, lay the molding with its
°
broad back surface flat on the miter table and against the
fence.
52
°
CEILING
38
°
W
A
L
L
FENCE
OPERATION
. Most
°
and a bottom rear angle (the
°
.
°
TOP EDGE AGAINST FENCE =
LEFT SIDE, INSIDE CORNER
RIGHT SIDE, OUTSIDE CORNER
MITER TABLE
CROWN MOLDING FLAT ON MITER TABLE
When setting the bevel and miter angles for compound
miters, remember that the settings are interdependent;
changing one angle changes the other angle as well.
Keep in mind that the angles for crown moldings are very
precise and difficult to set. Since it is very easy for these
angles to shift, all settings should first be tested on scrap
molding. Also most walls do not have angles of exactly
90 , therefore, you will need to fine tune your settings.
°
When cutting crown molding by this method the bevel
angle should be set at 33.9
molding stops are marked either 33.9
angle for cutting crown molding (see figure 40).The miter
angle should be set at 31.62
on the desired cut for the application. See the chart below
for correct angle settings and correct positioning of crown
molding on miter table.
The settings in the chart on page 30 can be used for cut-
ting All Standard (U.S.) crown molding with 52
angles. The crown molding is placed flat on the miter table
using the compound features of your miter saw.
INSIDE
CORNER
FENCE
29
either right or left. The crown
°
or 45 for the exact
° °
either right or left, depending
°
°
OUTSIDE
CORNER
BOTTOM EDGE AGAINST FENCE =
RIGHT SIDE, INSIDE CORNER
LEFT SIDE, OUTSIDE CORNER
MITER TABLE
and 38
°
Fig. 39