Logging; System - Pioneer SGX-CA500 User Manual

Logging

Use the settings below to configure the logging operation.
Settings marked with an asterisk (*) are initial factory defaults.
Setting Item
Auto Lap
Auto Pause/Resume
Trigger Threshold
Logging Interval
Reminder

System

Use the settings below to configure Cyclocomputer system-wide settings.
Settings marked with an asterisk (*) are initial factory defaults.
Setting Item
GPS GPS Enable/Disable
GPS Speed
(GPS status)
Battery (Battery status)
Charge Mode
Sound Audio Volume
Audible Selection
Display Brightness
Contrast
Touchscreen Calibration
Altitude Calibration Current Altitude
Calibration Type
Setting Value
Calibration
Enable or disable* Auto Lap.
Select the check box to enable Auto Lap.
Ü Auto Lap Settings (page 24)
Enable* or disable Auto Pause/Resume.
Select the check box to enable Auto Pause/Resume.
Ü Auto Pause/Resume Settings (page 22)
Specify the Auto Pause/Resume speed threshold value.
Specify the logging interval.
Specifying [Auto] causes the logging interval to be adjusted automatically within a range 1 to
10 seconds in accordance with riding speed.
• Auto
• 1 sec*
• 3 sec
• 5 sec
• 10 sec
Enable or disable* Reminder.
Select the check box to enable Reminder.
Ü Reminder Settings (page 23)
Enables* and disables GPS.
Check the box to reflect time information from GPS to the date and time of the
device.
Switches GPS Speed function on* or off. Check the box to display speed and
distance obtained from GPS.
You can select this function only when [GPS Enable/Disable] is on. Errors may
occur between displayed value and actual value depending on the signal. If the
speed sensor is connected, the value from the sensor is displayed as a priority.
Displays the GPS position status (no positioning, 2D, 3D).
Shows the device remaining battery charge and charge condition.
Ü Checking the Battery Level (page 6)
Specify the charging mode setting.
• Normal Charge*
• Boost Charge
Ü Charging Mode Setting (page 7)
Adjust the device speaker volume to one of six levels.
• 0 - 3* - 5
Turn the audible selection tone for touch panel menu item selection on* or off.
Audible selection is turned on when the check box is selected.
Adjust the display brightness.
Touch the screen, adjust brightness, and then tap [OK].
Adjust the display contrast.
Touch the screen, adjust contrast, and then tap [OK].
Calibrate the touch panel.
Ü Calibrating the Touch Panel (page 47)
Displays the current altitude.
Specify the altitude calibration type.
• Current Altitude*
• Sea-level Pressure
• GPS
Enter an altitude setting value.
Tap to calibrate the altitude.
Description
Description
Cyclocomputer Settings
45
EN