Advertisement
9. INSTALLATION
I
WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ...................................................................... 18
2) Package Contents ................................................................. 18
3) General Cautions .................................................................. 18
4) Cautions on Installation ......................................................... 18
5) Installing the Source Unit ...................................................... 18
6) Removing the Source Unit .................................................... 19
7) Wiring and Connections ........................................................ 20
8) Connecting the accessories .................................................. 20
1) Before Starting
1. This set is exclusively for use with a negative
ground 12 V power supply.
2. Read these instructions carefully.
3. Be st,Jre to disconnect the battery ''terminal" before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
Figure 1
Battery
Source unit .................................................. 1
Owner's manual. ..........................................
1
Front panel ..................................................
1
Trim ring ......................................................
1
Mounting bracket.. .......................................
1
L-key ............................................................ 2
Power supply cable .....................................
1
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
18
CZ505
Warranty card ..............................................
1
Special screw
(M2*5mm,front panel lock) ........ 1
Screws M5x6 mm Double Sems .................
4
Remote control unit .....................................
1
Battery (CR2025) ......................................... 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
4) Cautions on Installation
1 . Prepare all articles necessary for in-
stalling the source unit before starting.
2. Install the unit within 30° of the hori-
zontal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult
your car dealer beforehand.
4. Use the enclosed screws for installa-
Max 30"
Figure 2
5) Installing the Source Unit
tion.
Using other screws can cause dam-
age.
(Figure 3)
Chassis
Chassis
t~~age
Max.
6
mm (M5 screw)
Figure 3
1. Place the mounting bracket into the instrument panel, use a screwdriver to bend
each stopper of the mounting bracket inward, then secure the stopper.
2. Wire as shown in Section 7).
3. Insert the source unit into the mounting bracket until it locks.
4. Take care of the top and bottom of the trim ring and mount it so that all the hooks
are locked.
Notes:
1. Some car models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
2. Fasten the front stopper securely to prevent the source unit from coming loose.
• Console opening dimensions
Advertisement
