Weider 8510 User Manual page 10

15. Route the Long Cable (23) around the "V"-
Pulley (6) on the Right Arm (48). Be sure
that the Cable is in the groove of the "V"-
Pulley and that the Long Cable Trap (50) is
turned to hold the Cable in place. Tighten
the 3/8" x 2 1/2" Bolt (7) and the 3/8" Nylon
Locknut (not shown).
16. Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the
groove of the Pulley and that the Cable
Trap (66) is turned to hold the Cable in
place. Tighten the 3/8" x 2" Bolt (12) and the
3/8" Nylon Locknut (not shown).
Be sure that the 5/16" x 5" Bolt (68) is proper-
ly tightened and that the Pulley Bracket (20)
can move freely.
17. See the inset drawing. Attach a 3 1/2" Pulley
(15) and a Cable Trap (66) to the indicated
hole in the Long "U"-Bracket (57) with a 3/8" x
2" Bolt (12) and a 3/8" Nylon Locknut (21). Be
sure that the Cable Trap is inside the "U"-
Bracket. Note: This may come pre-assem-
bled.
Route the Long Cable (23) around the 3 1/2"
Pulley (15) and through the Long "U"-Bracket
(57). Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly.
18. Note: The Pulley (15) in this drawing is
pre-assembled. It is shown disassembled
for easy part identification.
Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8" x 2" Bolt (12)
and the 3/8" Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley
and that the Cable and Pulley move
smoothly.
10
15
7
50
6
48
23
16
68
66
20
12
15
23
17
23
23
15
66
12
21
57
18
15
23
Bracket
12
55
21
29. Rest the Seat Frame (36) on the indicated pin
in the Front Upright (42). Attach the Seat
Frame to the Front Upright with a 5/16" x
2 3/4" Carriage Bolt (14) and the Seat Knob
(40).
30. Press 3/4" Round Inner Caps (34) into the
ends of both 12 1/2" Pad Tubes (28).
Insert one 12 1/2" Pad Tube (28) into the
Seat Frame (36). Slide a 5 1/2" Pad (30) onto
each end of the Pad Tube.
Insert the other 12 1/2" Pad Tube (28) into the
Leg Lever (29). Slide a 5 1/2" Pad (30) onto
each end of the Pad Tube.
15
29
40
36
14
Pin
42
30
30
36
34
28
34
30
29