Introduction; Receiving & Inspecting The Unit - N'Finity 3000 User Manual

Thank you for purchasing an N'FINITY cooling unit. We strive to provide the highest quality products and the best possible customer
service. If you have any questions about your N'FINITY unit, please call us at 1-800-648-6058.
This User's Manual is intended to assist in the proper installation and maintenance of the N'FINITY cooling system. In order to ensure
the longevity of your cooling unit, the equipment should be installed properly and have a proper care and maintenance schedule.
Please read and review this manual carefully and keep it for future reference.
What Is the N'FINITY Cooling System?
The N'FINITY system is a specialized refrigeration unit designed for one purpose only: to maintain the optimal temperature and
humidity levels conducive to the proper storage and aging of fine wines. It is a self-contained cooling unit designed to be used as a
forced-air through-the-wall unit. The system is fully self-contained and can be installed as a through-the-wall application. The stan-
dard through-the-wall units are temperature controlled via air sensor. The N'FINITY unit can be set at any temperature within the
acceptable wine-aging range of 50°F to 67°F. It is designed to cool 30°F cooler than the ambient temperature of the space to which it is
exhausting.
Please refer to pages 15 for complete terms and conditions, warranty guidelines, and policy for your cooling unit.
Receiving and Inspecting the Unit
Note: N'FINITY units are manufactured in the USA and tested prior to shipment.
•
Lift only at the designated hand hold locations on the shipping container or fully support the unit from underneath.
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
Review the Packing Slip to Verify Contents
•
Check the model number to ensure it is correct.
If any items listed on the packing slip do not match your order information, contact Wine Enthusiast Tech Department immediately at
1-800-648-6058.
Check the Accessory Kits for the following contents:
Kit One:
•
N'FINITY Owner's Manual
Kit Two:
•
11' Power Cord
•
10 - 1 3/4" #6 Screws
•
6 - 1/2" Self Tapping Screws
•
1 - 10 ft. 3/8" Drain Line tube
•
1- 3/8" Barb Fitting
•
4 - Insulation Foam Strips
•
1 - Mounting Bracket
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product safely without
damaging it. When you are ready to remove the product from the box, refer to page 6-9 for installation instructions.
Note:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.

INTRODUCTION

RECEIVING & INSPECTING THE UNIT
Page 3