Version 2 Controller Functions - N'Finity 3000 User Manual

Menu Navigation
& Value Increase
*Press and hold
to manually enter
defrost mode.
Menu Navigation
& Value Decrease
Button/Symbol
•
ON/OFF
•
•
Up and Down
•
•
SET
•
•
•
•
Snowflake Constant - Unit is in cooling mode and the compressor and fans are running.
Blinking - The unit is calling for cooling, but must wait 5 minutes before restarting the compressor. This 5
minute delay serves as an anti-short cycle for the compressors protection.
Dripping Snowflake Unit is in defrost mode. The compressor and fans will be turned off during this cycle.

VERSION 2 CONTROLLER FUNCTIONS

Compressor On
Unit is in Defrost Mode
Press and hold the on/off button for approximately 3 seconds to turn the unit on or off.
Note: This does not disconnect power from the unit. In order for the power to be shut off from
the unit, the power cord must be unplugged from the wall receptacle.
This button also serves as an escape button.
Use these buttons to scroll up or down a menu.
Press and hold the up button for approximately five seconds to manually start the defrost sequence.
Press the set button once to view the set point, temperature of the air sensing probe.
Once the set button is pressed "SEt" will be displayed. Press the up or down arrows to scroll through
Pb1 and the set point parameter.
Press the set button again to view any of these values.
To change the set point, press the set button when "SEt" is displayed on the screen. The current set
point will be displayed. Use the up or down arrows to change the set point to the desired temperature.
Press the set button again once the desired temperature is reached.
Hold the set button for approximately 5 seconds to enter the CPSM (Customer Preference Selection
Mode) menu. (CPSM detail on next page)
Alarm is Present
Temperature Measurement
Normal Functions
Power On/Off
(hold for approx. 3 seconds)
& Escape
Probe Value &
Alarm Folder
*Press and hold to
enter the parameter
menu.
Page 11