Receiving And Transmitting - Icom IC-A120 Basic Manual

■ Receiving and transmitting

1. Setting the frequency
Setting the frequency in the Memory mode
1) Open the "MEMORY" menu.
➥ Push [ /MHz/GRP].
2) Open the "GROUPS" menu.
➥ Push [∫] or [√], and then push [ /MHz/GRP].
3) Select a desired group.
➥ Push [∫] or [√], and then push [ /MHz/GRP].
4) Select a desired channel.
➥ Push [∫] or [√].
Setting the frequency in the VFO mode
(For only EXP and EUR versions.)
1) Set the MHz digit.
➥ Push [ /MHz/GRP], and then push [∫] or [√].
• The MHz digit blinks.
2) Exit the MHz Digit Selection mode.
➥ Push [ /MHz/GRP] again.
3) Set the kHz digit.
➥ Push [∫] or [√].
TIP: You can select the channel spacing in the "CH
SPACING" menu*.
MENU > SETTINGS > FUNCTIONS > CH SPACING
* The menu may not be displayed, depending on the transceiver's
setting. Ask your authorized Icom dealer or transceiver
administrator for details.
CAUTION: Use of 8.33 kHz Channel Spacing of this radio
is strictly prohibited and shall not be used in Canada.
2
BASIC OPERATION
1
02
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4