Q Acoustics Media BT3 Manual page 14

Instructions
SOURCE VOLUME CONTROL
Audio sources will initially be set at a DEFAULT volume level. The volume can be adjusted separately for
each source using the VOL + and VOL – buttons on the top panel or IR remote. Once adjusted, the unit will
remember the new volume level for the currently selected source, and will return to that level each time
that source is re-selected.
PAIRING A BLUETOOTH DEVICE
The unit is designed to automatically go into pairing mode if there is no Bluetooth device connected. To Pair
your Bluetooth source:
1. Turn the unit and the Bluetooth device ON.
2. Make sure Bluetooth is enabled on the device to be Paired. The Bluetooth controls are typically found
in the device's 'Settings' or 'Connections' menu.
3. On your device's list of discoverable devices, you should now see 'Q-BT3-XXX' where XXX is a pre-defined
three digit number. (Refer to Rear Panel section for the Bluetooth name label.)
4. Select 'Q-BT3-XXX' and your device will now be Paired via Bluetooth and Connected.
5. From within the music player on your device, select 'Q-BT3-XXX' as the audio output and press Play. Unless
the remote has been used to manually select another source and override Auto-Source Selection, the
unit will switch to Bluetooth input and the LED will turn Blue.
Please Note:
Although starting to Play a track on the connected source will cause the unit to switch to Bluetooth, the unit will stay on
Bluetooth until the source is disconnected. It will not switch to another source whilst the player is paused.
Please Note:
Auto-Source Selection will switch to Bluetooth the first time a connected device sends any audio signal including
message received alerts and key press effects.
Please Note:
When connected, the device's volume and mute controls control the device itself, not the unit. Better audio quality will
be achieved by having the device set at a higher volume level and the unit at a lower level.
14