Summary of Contents for Q Acoustics Concept Series
Page 1
Concept Series User Manual and Product Specification...
Page 3
Important Information - Please Read Carefully Read these instructions. Unplug this apparatus during lightning storms or Keep these instructions. when unused for long periods of time. Heed all warnings. Follow all instructions. Warning: To reduce the risk of fire or electrical Do not use this apparatus near water.
DO NOT expose your loudspeakers to excessive cold, heat, humidity or sunlight. If you play your loudspeakers without their grilles on, be careful to protect the The Q Acoustics Concept Series is a range of loudspeakers designed to meet the drive units from damage.
Page 5
Preparation Spikes are sharp. Exercise care! Never place a spiked loudspeaker where it can cause damage! Always move your loudspeakers by lifting them - never drag them! Fitting the Floorstand Spikes - Concept 40 Warning Do not use close to a strong heat source - radiators, heaters or electrical equipment. Do not expose the stands to excessive cold, heat, humidity or sunlight.
Page 6
Foam Bung Concept 40 The Concept Series speakers are rear ported and designed to work best with The Concept 40 loudspeakers should be positioned at least 200mm from a back some space behind them i.e. 200mm or so away from a wall. If you position your wall and 500mm from the side walls.
Connecting Passive Loudspeakers Terminals and Connectors Loudspeaker Cables The Concept 20s and 40s are bi-wireable. A bi-wireable crossover has four Specialist loudspeaker cables will offer a higher standard of reproduction than terminals. The upper pair of terminals connect to the treble (HF) speaker and the general purpose ‘bell’...
Connecting Passive Loudspeakers Stereo Connections Bi-Wiring Directly connecting the treble and bass networks of a loudspeaker to an Standard Connections amplifier improves both bass performance and dynamic range. Connect the RED (+) terminal of the RIGHT loudspeaker to the RED, Positive (+) To bi-wire: Prepare two twin cables for each loudspeaker.
During the warranty period Q Acoustics will, at its option, repair or replace any Then lightly buff with a cloth to remove any residue of the cleaning agent. Never product found to be faulty after inspection by the company or its appointed use abrasives of any kind.