Operation - Q Acoustics Media BT3 Manual

Operating Q-BT3
POWER AND STANDBY
Power on the unit at the AC SWITCH once all rear panel audio connections are made. The speakers will enter
STANDBY, with a RED status LED.
Exit STANDBY by pressing the STANDBY button on either the top panel or the IR remote. The LED will
initially turn Green but may then change according to the Auto-Source Selection rules.
If NO input signals are detected, the unit will automatically enter STANDBY after 20 minutes.
AUTO-SOURCE SELECTION
In normal operation the unit will automatically select the audio source. A Connected Bluetooth source that
starts to play has the highest priority, followed by Digital and finally Analogue:
The Auto-Source Selection can be manually overridden at any time using SOURCE SELECT on the IR remote
or by a short press of the
Important Note:
The unit will stop using Auto-Source Selection when the source is manually selected using the Source Select button on
the remote, or a short press of the Standby Button on the unit. Auto-Source Select will resume once the unit has been
put into and out of Standby.
Bluetooth
Optical input
Line in 2
Line in 1
Standby
button on the unit.
INPUT
PRIORITY
13
Instructions