Lubrication - TGB BR8 Service Manual

3-6

LUBRICATION

3-6-1 Engine oil level
The engine must be in cold and the scotter
positioned uprightly on its stand flat ways.
Inspect the oil level with the oil meter that
remove
it from the crankcase.
If the level is close to the minimum point and
the oil is not to be renewed, fill up with oil of
the recommended type.
3-6-2 Oil renewal
Renew the oil easily while the engine is in hot
condition.
Place a vessel under the engine, remove the
outlet bolt and the oil lever gauge.
After draining the oil, clean the oil lever gauge
(check the O-ring seal) and fit the oil lever
gauge and outlet bolt again.
Tightening torque: 150 kg-cm
Supply the engine with recommended oil
through the oil filter
Screw the filler plug.
Lubrication Type: SAE 10W-40
Engine oil capacity
*BH8/BR8/BF8*
125c.c. Engine disassembled:900c.c.
Chang oil: 750c.c.
*BR9/BF9*
151c.c. Engine disassembled:1000c.c.
Chang oil: 800c.c.
Note: Run the engine after a few minutes, then recheck the oil level again when the engine
is until cold condition. The oil level should always be kept below the max. lin and
above the min. line.
59