Fasten The Door Bracket - Craftsman 139.53927 Owner's Manual

INSTALLATION STEP 12
Fasten Door Bracket
Follow instructions which apply to your door type
as illustrated below or on the following page.
A horizontal brace should be long enough to be
secured to 2 vertical supports. A vertical brace
should cover the height of the top panel.
The illustration shows one piece of angle iron as the
horizontal brace. For the vertical brace, 2 pieces of
angle iron are used to create a "U"-shaped support
(Figure 1). The best solution is to check with your
garage door manufacturer for an opener installation
door reinforcement kit.
NOTE: Many vertical brace installations provide for
direct attachment of the clevis pin and door arm. In
this case you will not need the door bracket; proceed
to Step 13.
SECTIONAL DOORS
• Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation. Note correct UP placement, as
stamped inside the bracket. (Figure 2).
• Position the bracket on the face of the door within
the following limits:
A) The top edge of the bracket 2"-4" (5-10 cm)
below the top edge of the door.
B) The top edge of the bracket directly below any
structural support across the top of the door.
Door
Bracket
Location
Vertical
Centerline
Header Bracket
WARNING
CAUTION
To prevent damage to garage door, reinforce inside of
door with angle iron both vertically and horizontally.
AVERTISSEMENT
HARDWARE SHOWN ACTUAL SIZE
ATTENTION
Nut 5/16"-18
• Mark and drill 5/16" (0.78 cm) left and right
fastening holes. Secure the bracket as shown in
Figure 1 if there is vertical reinforcement.
If your installation doesn't require vertical reinforce-
ment but does need top and bottom fastening holes
for the door bracket, fasten as shown in Figure 2.
Horizontal and vertical reinforcement
is needed for lightweight garage doors
(fiberglass, aluminum, steel, doors with
glass panel, etc). (Not Provided)
Carriage Bolt
Inside Edge
5/16"-18x2-1/2"
of Door or
Reinforcement Board
Door
Bracket
UP
Door Bracket
Figure 2
24
Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Vertical
Reinforcement
Vertical
Centerline
UP
Lock Washer
5/16"
Nut
5/16"-18
Figure 1