KTM 350 EXC-F EU 2015 Setup Instructions page 9

2 SETUP
(EXC‑F EU, EXC‑F AU, EXC-F SIX DAYS)
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with the connector that is marked
green.
601711-01
(EXC-F US)
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with the connector that is marked
green.
C00117-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
–
–
–
–
101393-12
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. (
–
Install the battery. (
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
–
Apply the label included in the delivery (optional).
–
Set kilometers or miles. (
–
Set the speedometer functions. (
–
Set the clock. (
–
Refuel. (
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.
Keep batteries out of the reach of children.
Wear suitable protective clothing and goggles.
Avoid contact with battery acid and battery gases.
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
p. 13)
p. 13)
p. 16)
p. 16)
p. 17)
p. 15)
7