KTM 350 EXC-F EU 2015 Setup Instructions page 14

3 WORK
3.9 Installing the front fender
3.10 Removing the seat
3.11 Mounting the seat
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
L02485-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
B01603-11
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
M00176-10

.
p. 10)
 .

.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 9)
M6 10 Nm (7.4 lbf ft)
12