Charging Battery - Echo DSRM-200 Instruction Manual

DSRM-200

Charging Battery

• Keep charger and battery away from damp conditions and all liquids.
• Connect the charger only to 120V AC outlet.
• Never insert objects in the battery pack's or charger's cooling slots (A).
Note: The battery comes partially charged from the factory and needs to be fully charged before first use.
Note: Charge the battery when it no longer produces sufficient power to operate the trimmer or when battery
lights indicate that the battery is low.
1. Plug charger AC cord into 120V AC outlet. Charger LED (B)
will blink GREEN.
2. Align ridges on battery with grooves on charger, and slide
battery into charger.
3. During normal charging, the charger LED will blink
continuously GREEN.
If charger detects a problem, LED blinks RED. Remove battery
from charger, clean contacts, and reinstall battery into charger.
If battery is outside acceptable temperature range (0°C to 45°C
or 32°F to 113°F) LED remains RED. Remove battery from
charger and warm or cool as needed, then reinstall battery into charger.
4. When charging is complete, LED will remain GREEN.
Note: A fully discharged battery pack will charge in about 50 minutes.
5. Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button (C), and
checking LED display (D).
• 1 red light indicates that the battery has 10-40% charge.
• 2 red lights indicate that the battery has 40-60% charge.
• 3 red lights indicate that the battery has 60-80% charge.
• 4 red lights indicate that the battery has 80-100% charge.
• One continuously flashing red light indicates the battery's
power level is below 10%. Charge the battery.
• 4 continuously flashing red lights indicates the battery is
completely discharged. Charge the battery.
6. Disconnect battery charger from power supply.
X7508161200
© 3/2014 ECHO Inc.
MAINTENANCE
A
C
B
D
21