Appendix A: Post Message - Gigabyte GA - 586STX User Manual

GA-586STX

APPENDIX A: POST MESSAGE

When the BIOS encounters an error that requires the user to correct
something, either a beep code will sound or a message will be displayed in a
box in the middle of the screen and the message PRESS F1 TO CONTINUE,
CTRL-ALT-ESC OR DEL TO ENTER SETUP will be shown in the
information box at the bottom.
•
POST BEEP
Currently there is only one beep code in BIOS. This code indicates that
a video error has occurred and the BIOS cannot initialize the video
screen to display any additional information. This beep code consists of
a single long beep followed by two short beeps.
•
ERROR MESSAGE
Once or more of the following messages may be displayed if the BIOS
detects an error during the POST. This list includes message for both
the ISA and the EISA BIOS.
Ö
CMOS BATTERY HAS FAILED
CMOS battery is no longer functional. It should be replaced.
Ö
CMOS CHECKSUM ERROR
Checksum of CMOS is incorrect. This can indicate that CMOS has
become corrupt. This error may have been caused by a weak battery.
Check the battery and replace if necessary.
Ö
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. Insert a system disk into Drive A: and press
<Enter>. If you assumed the system would boot from the hard drive,
make sure the controller is inserted correctly and all cables are properly
attached. Also be sure the disk is formatted as a boot device. Then
reboot the system.
A-1