Stihl MS 362 C-Q Instruction Manual page 6

English
Wear steel-toed safety
boots with cut retardant
inserts and non-slip
soles.
Wear a safety hard hat
where there is a danger
of head injuries from fall-
ing objects.
Wear safety glasses or a face shield
and hearing protection e.g. earplugs or
ear muffs.
Wear heavy-duty
gloves.
STIHL offers a comprehensive range of
personal protective clothing and
equipment.
Transporting the Chain Saw
Always engage the chain brake and fit
the chain guard (scabbard) before
carrying the saw short distances. Also
stop the engine before carrying the saw
longer distances (more than about 50
m).
Always carry the saw by the front handle
(handlebar) – with the hot muffler away
from your body – the guide bar must
point to the rear. To avoid serious burn
injuries, avoid touching hot parts of the
machine, especially the surface of the
muffler.
Transporting in a vehicle: Properly
secure your power tool to prevent
turnover, fuel spillage and damage.
4
Fueling
Gasoline is an
extremely flammable
fuel. Keep clear of naked
flames. Do not spill any
fuel – do not smoke.
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Fuel your power tool only in well-
ventilated areas. If you spill fuel, wipe
the machine immediately – if fuel gets on
your clothing, change immediately.
Your power tool comes standard with
either a screw-type or bayonet-type fuel
cap.
After fueling, tighten
down the screw-type fuel
cap as securely as
possible.
Insert the fuel cap with
hinged grip (bayonet-type
cap) correctly in the
opening, turn it clockwise
as far as stop and fold the
grip down.
This reduces the risk of unit vibrations
causing the fuel cap to loosen or come
off and spill quantities of fuel.
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
– Check operation of chain brake,
front hand guard
– Correctly mounted guide bar
– Correctly tensioned chain
– Smooth action of throttle trigger and
throttle trigger interlock – throttle
trigger must return automatically to
idle position.
– Master Control lever / stop switch
must move easily to STOP or 0
– Check that the spark plug boot is
secure – a loose boot may cause
arcing that could ignite combustible
fumes and cause a fire.
– Never attempt to modify the controls
or the safety devices in any way.
– Keep the handles dry and clean –
free from oil and pitch – for safe
control of the chain saw.
To reduce the risk of personal injury,
do not operate your saw if it is damaged
or not properly assembled.
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and secure footing. Hold the unit
securely. The cutting attachment must
MS 362 C-Q