Option Settings; Shutter; Osd; Auto Keystone - Panasonic PT-L780NTE Operating Instructions Manual

Option settings

Select the item pressing the F or G
buttons on the remote control unit or
the projector.
Press the I or H buttons to adjust
the selective items. To make the
SHUTTER or WEB PASSWORD
(PT-L780NTE only) functions work,
press the ENTER button.
OPTION

SHUTTER

OSD

AUTO KEYSTONE

RGB/YPbPr

RGB2 SELECT

BACK COLOR
FRONT/REAR
DESK/CEILING
LAMP POWER
LAMP RUN TIME
NEXT PAGE @
SELECT:[^][@]
ADJUST:[{][}]
OPTION
PREVIOUS PAGE ^
FAN CONTROL STANDARD
WEB CONTROL
WEB STANDBY
WEB PASSWORD
CONTROL KEY
FUNC1
SET ID
AUTO POWER OFF DISABLE
SELECT:[^][@]
ADJUST:[{][}]
SHUTTER
The shutter function can be used to
momentarily turn off the picture and
sound from the projector when the
projector is not being used for short
periods of time, such as during
breaks in meetings or when carrying
out preparation. The projector uses
less power in shutter mode than it
does in normal projection mode.
46-E
NGLISH
OFF ON
OFF ON
RGB YPbPr
INPUT OUTPUT
BLUE BLACK
FRONT REAR
DESK CEILING
LOW HIGH
10 H
ENTER:[ENTER]
ESC:[MENU]
HIGH
OFF ON
OFF ON
OFF ON
MUTE KEYSTONE
ALL
ENTER:[ENTER]
ESC:[MENU]
OSD
ON
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
OFF
Use this setting when you do not want
the current input name to be displayed.
AUTO KEYSTONE
This should normally be set to ON.
ON
During automatic setup, the angle of
tilt of the projector is detected and
vertical keystone distortion is
corrected automatically.
OFF
Use this setting when you do not
want automatic keystone correction
to be carried out during automatic
setup, such as when the screen
itself is at an angle.
RGB/YPbPr
This setting is valid when 750p,
HDTV60, HDTV50, 525p, 625i and
525i signals are being input. Select
the setting in accordance with the
input signal.
The RGB/YPbPr item is displayed
when an RGB1 IN, RGB2 IN or
RGB 3 IN connectors has a signal
being input.
RGB2 SELECT
This setting is used to select the
function of the RGB2 IN/RGB OUT
connector.
The selected input source (RGB1 or
RGB3) is output when RGB OUT is
selected.