Example Of Connecting To Video Equipment - Panasonic PT-L780NTE Operating Instructions Manual

Example of connecting to video equipments
Computer for
control use
D-sub 9-pin
(male)
USB RGB1 IN
SERIAL
R/R-Y/P
REMOTE
R
DVD player
Red (connect to P
Blue (connect to P
Green (connect to Y signal connector)
NOTE:
B Only one audio system circuit is available for the AUDIO IN L-R jacks for
S-VIDEO/VIDEO signals, so if you wish to change the audio input source,
you will need to remove and insert the appropriate plugs.
B Only one audio system circuit is available for the RGB AUDIO IN jacks, so
if you wish to change the audio input source, you will need to remove and
insert the appropriate plugs.
B If an audio system is connected to the AUDIO OUT jack, the sound
volume balance can be controlled by the remote control unit which is
supplied with the projector.
B If the video signal source is connected using a cable with a BNC
connector plug, use a BNC/RCA adapter (sold separately) to convert the
cable end to an RCA plug-type jack.
B Refer to page
to the projector.
B If the signal cables are disconnected or if the power supply for the
computer or video deck is turned off while the digital zoom function is
being used, this function will be cancelled.
26-E
NGLISH
D-sub 15 (male) - BNC5 (female)
adapter cable (sold separately)
Red (connect to P
Blue (connect to P
Green (connect to Y signal connector)
DVI-D IN
RGB2 IN/RGB OUT
G/Y B/B-Y/P SYNC/HD VD
B
RGB3 IN
signal connector)
R
signal connector)
B
63 for a list of compatible YP
signal connector)
R
signal connector)
B
Digital broadcast
tuner or DVD player
S-VIDEO IN
L
AUDIO OUT
R
RGB AUDIO IN AUDIO IN
VIDEO IN
Audio system
P signals which can be input
B R
DVD player
Video deck