Starting To Use; Turning On The Power - Panasonic PT-L780NTE Operating Instructions Manual

Starting to use

Turning on the power

Please ensure that all preparations have been completed before turning on
the power. (Refer to pages
# Remove the lens cover.
$ Connect the accessory mains lead.
% Press the MAIN POWER switch to
the "l" side to turn on the power.
The power indicator on the projector
will illuminate red.
& Press the POWER button.
The power indicator on the projector
will flash green. After a short period,
the indicator will illuminate green, and
a picture will be projected.
' Press the input select (RGB, VIDEO)
button to select the input signal.
The input signal selected will change
as shown at below each time an input
select button is pressed.
VIDEO
VIDEO
( While pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector.
To make fine adjustments to the angle of
tilt of the projector, turn the front
adjustable legs. (The front adjustable legs
will be locked if they are fully extended
and then turned anticlockwise. Turn them
back clockwise to release the lock.)
) Press the AUTO SETUP button to
initiate automatic positioning.
The automatic positioning is only for vertical
keystone distortion. To correct the
horizontal keystone distortion or when
keystone distortion has not been corrected
to the optimum level, carry out the keystone
correction as described on page 42.
30-E
NGLISH
24 – 29.)
RGB
S-VIDEO
VIDEO
$
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
– + MENU
ZOOM
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
– + MENU
ZOOM
SD CARD
RGB
NETWORK
DVI
RGB3
RGB2
RGB1
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
– + MENU
ZOOM
%
LAMP TEMP
INPUT
VIDEO RGB SHUTTER
AUTO
POWER SETUP
RGB LASER
VIDEO MENU
PAGE
ENTER
LAMP TEMP
INPUT
AUTO
POWER SETUP
VIDEO RGB SHUTTER
RGB LASER
VIDEO MENU
PAGE
ENTER
TEMP
LAMP
INPUT
VIDEO RGB SHUTTER
AUTO
POWER SETUP
RGB LASER
VIDEO MENU
PAGE
ENTER