Installation
Install the window/door sensor in the same position where proper operation was
confirmed (page 10). You can install the window/door sensor using screws or
double-sided tape, depending on your preference or the material of the installation
area.
Note:
R When installing, make sure the battery is inserted properly and the sensor unit
cover is completely closed.
R Use screws when installing on a wooden surface. Do not use double-sided tape.
Securing with screws
1
Remove the covers from each unit.
R Lift from the indented area (A) and open the sensor unit cover (B).
HNS101AZ_(en_en)_0325_ver.031.pdf
13
Setup
13
2015/03/25
14:20:39