Table of Contents
Advertisement
Appendix
Testing the window/
door sensor
You can check the window/door
sensor's LED indicator and test the
performance of the window/door
sensor.
1
Remove the sensor unit cover.
2
Press M
3
Open and close the window or
door several times.
R Make sure that the LED
4
Press M
Note:
R If the LED indicator lights in red
when the window or door is closed,
the window/door sensor is not
installed properly. Re-evaluate the
position of the sensor unit and
magnet unit (page 10).
Features available
when using the
[Home Network] app
Some of the window/door sensor's
features that are available when using
the [Home Network] app are listed
below. For more information, refer to
the User's Guide (page 17).
– Alarm system
You can use the app to arm and
disarm the alarm system, confirm
the current status of the sensor, and
view a log of previous events.
– Sensor integration
16
HNS101AZ_(en_en)_0325_ver.031.pdf
N on the sensor unit.
indicator lights in green when
you close the window or door.
N again.
16
You can configure the window/door
sensor to trigger other system
events, such as camera recording,
turning on an electric device (such
as a lamp), etc. (Appropriate device
required.)
– Telephone alert
You can configure the system to call
a preprogrammed phone number
when the window/door sensor is
triggered.
2015/03/25
14:20:39
Advertisement
Table of Contents
