Table of Contents
Advertisement
Securing with double-sided tape
Note:
R Make sure the surfaces of the sensor unit, magnet unit, and the installation area
are clean and dry before applying double-sided tape.
1
Check that the sensor unit cover and magnet unit cover are attached.
2
Affix double-sided tape to the sensor unit and magnet unit.
R Make sure the tape covers the screw holes on the back of each unit.
3
Install the sensor unit and magnet unit.
R Press firmly on each unit to ensure solid adhesion to the installation surface.
Important:
R
5
point directly at each other and are no more than 25.4 mm apart.
Removing when secured with double-sided tape
1
Tie a piece of thread to two sticks, screwdrivers, etc.
2
Pull the thread tight and use it to cut the double-sided tape, and then remove
any excess tape.
1
HNS101AZ_(en_en)_0325_ver.031.pdf
Align the " " marks on the sensor unit and the magnet unit so that they
Excess tape
15
5
1
Setup
15
2015/03/25
14:20:39
Advertisement
Table of Contents
