Makita JS1600 Technical Information page 2

C
apacity
Plate thickness
Kinds of plate
Soft steel plate
Stainless plate
In the above test, we fixed the cut width to be 10-15mm and the fixing method of the materials is as shown by Fig.1
which is supposed to practice commonly. Also, in shear cutting, the maximum cut width possible is shown as
follows, for the cutting capacity depends on the cut width.
(Maximum cut width)
In case of cutting a plate of 3-shaku(900mm) x 6-shaku(1800mm)
900
(Minimum cut radius)
Minimum cut radius = 30 mm (when cut a soft steel plate 1.0mm)
R
epair
[Disassembly order and Notes]
1. Remove the shear blade by taking off the hexagonal-hole bolt fixing the upper shear blade to blade holder with
the accessory hexagonal spanner 3.
2. Remove Gear-housing by taking off the pan-head small screw fixing Gear housing, Gear housing cover and
Motor housing in 4 corners, with a + screw driver.
3. Remove the yoke by about three-time-turn loosening of a
setscrew fixing yoke to gear-housing.
4. When you remove the yoke,
you can take out the part in
the rigc bbb ht drawing from
the gear-housing.
Load current
(mm) (A)
0.5 1.5-1.6
1.0 1.7-1.8
1.6 2.4-2.6
0.8 1.5-1.6
1.0 1.7-1.9
1.2 2.5-2.8
A
1800
Clunk shaft complete
Table – 1
Cutting speed
(m/mm)
6.7
6.7
5.6
5.5
5.5
5.2
<Fig.1>
Soft steel plate(mm)
Maximum cut width A(mm)
Stainless plate(mm)
Maximum cut width A(mm)
Washer6
Washer10
Ball bearing627
Needle bearing1012
No. of Striking
(times /min)
3730-3860
3530-3630
2870-3020
3730-3860
3430-3630
2740-2950
Claps of materials
Cutting section
Material
of board
Table
Table – 2
t=1.6
100
t=1.2
80
Rod
Blade holder
pin6
Flat washer7
t=1.2
No limit
t=1.0
No limit
Gear housing
Setscrew
Protector
Yoke