Door Hinge Receivers - GE JKS10 Technical Service Manual

3. Remove four ¼-in. hex-head screws and the
duct cover from the oven.
Duct Cover
4. Remove seven ¼-in. hex-head screws and the
cooling fan cover from the oven.
5. Disconnect the cooling fan wire harness.
6. Remove three ¼-in. hex-head screws and the
cooling fan from the oven.
Cooling Fan
Cooling Fan Cover
Disconnect

Door Hinge Receivers

To remove the door hinge receivers:
1. Remove the side access panels. (See
)
Removal.
2. Carefully lift the insulation from the outside of
the oven.
3. Remove the four T-15 screws (2 on each side)
that hold each hinge receiver to the oven frame.
Note: Upon reassembly, ensure displaced that the
insulation around the oven and its components is
returned to its original position.
Thermal Line Break Thermal Cutout (TCO)
A self-resetting, disc-type thermal cutout switch
is attached to the rear of the oven. The switch
will open the L2 leg of the power to the heating
elements in the event of an over-temperature
condition. The switch on the upper oven will
open when the panel it is attached to reaches
approximately 302°F and will close as the panel
cools to approximately 272°F. The switch on the
single and lower ovens will open when the panel it is
attached to reaches approximately 284°F and close
as the panel cools to approximately 254°F. There
is no indication to the customer when the switch
opens or closes.
To replace the TCO:
1. Remove the rear covers. (See
2. Disconnect and remove two ¼-in. hex-head
screws and the TCO from the oven.
– 44 –
Oven
.)
Oven Removal
TCO