GE JKS10 Technical Service Manual page 40

Door Lock - Unlocked Position
Strip Circuit
Y BU
UNLOCK SW
Y
HIGH TEMP
THERMAL SW
UNLOCKED
To remove the lock assembly on single and upper
double ovens:
1. Gain access to the control compartment. (See
Access Control Compartment
2. Mark and disconnect the cooling fan connector.
3. Mark and disconnect the light housing
connector.
4. On double ovens, mark and disconnect all
connectors on the auxiliary control board, if
equipped.
Auxiliary Control Board
Cooling Fan Connector
LOW TEMP
THERMAL SW
BU
O
LOCK SW
Y
.)
Light Housing Connector
5. Hold the control panel and open the oven door.
6. Place the control panel on the protected oven
door as shown.
7. Lift the metal air divider.
1
8. Mark and disconnect the connectors from the
2
3
lock assembly.
4
5
9. Remove 2 Phillips-head screws and the lock
6
assembly from the oven.
Caution: It is possible to reconnect the switch wiring
incorrectly to the lock assembly. When reconnecting
the wiring, make sure it is properly connected to the
lock assembly before turning the power back on.
– 40 –
Lock Assembly
(Continued Next Page)