GE JKS10 Technical Service Manual page 30

To remove the outer door assembly:
1. Remove the door.
2. Place the inner door assembly, gasket side up,
on a protective surface.
3. Remove the three T-15 Torx screws from the
bottom of the outer door assembly.
4. Remove the four T-15 Torx screws (2 on each
side) from the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
5. Separate the inner door assembly from the
outer door assembly.
6. Remove the four ¼-in. hex-head screws and
spacers that hold the door handle to the outer
door assembly.
Door Shown with Inner Door Assembly Removed
Outer Door Assembly
Caution: Care must be taken if reinstalling the door
handle. Over-tightening the screws can damage the
handle. Hand-tighten the screws and make sure the
handle fi ts snugly to the door panel. (Do not use an
electric driver.)
To replace the inner door assembly:
1. Remove the outer door assembly. (See
.)
Assembly
2. Remove the four T-15 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
3. Remove the four ¼-in. hex-head screws that
attach the glass and side brackets (glass closet
to the outer door glass) to the inner door.
4. Remove the two ¼-in. hex-head screws that
hold the heat defl ector to the heat barrier.
Door
– 30 –
(Continued next page)