Ness Security Products Securityguard III Programming Manual page 9

ALARMS
INTRUDER ALARMS
Following this type of alarm the internal and external sirens sound and strobe flashes. The siren will
turn off after the programmed siren time and the strobe will flash for 1 hour or 12 hours while mains
power is connected.
The OFF button cancels any alarm and puts the SecurityGuard into the DISARMED state.
When disarming after an alarm, the SecurityGuard will indicate an alarm has occurred. The strobe
flashes and siren will beep rapidly for 5 seconds (both internal and external, even if external chirps are
disabled).
This warning may indicate that an intruder is still present.
The source of the alarm is then displayed for 5 minutes. Intruder alarms are not indicated when the
system is in ARMED, HOME or HOME 2 modes.
A time stamp is appended to each of the following alarm messages displayed when displayed. For
example, if the alarm occurred within 24 hours, the time stamp is appended as: ... < 2 HRS < 15 MIN
< AGO; for events older than 24 hours: ... < 1 DAY < 13 HRS < AGO.
DISPLAY DESCRIPTION
ALARM SecurityGuard integral detector
ALARM <
SENSOR <
1
ALARM from peripheral radio detector
ALARM <
SENSOR <
2-23
SIREN TAMPER
TAMPER <
SIREN <
Tamper is excluded if unsealed when powered up.
BOX
SIREN < TAMPER < EXCLUD is flashed on the
status display and warning beeps sound to indicate
tamper is excluded. Arming and then Disarming the
system will clear this display and disable the tamper
function.
When not excluded, a Tamper activation will:
1. In ARMED mode, sound a full alarm
2. In HOME, HOME 2 or DISARMED modes, sound
a low-volume warning sound. The warning will
sound again for further Tamper
deactivation/reactivations
Tamper deactivation will cause an alarm restore,
however the Alarm log will only clear after an
Arm/Disarm cycle.
After Arm/Disarm, if the Tamper is still active, it will
remain in the Alarm log. If it is then deactivated, the
Alarm log will immediately clear.
Sensor has reported a tamper alarm.
TAMPER <
SENSOR <
Tamper activation will:
2-23
1. In ARMED mode, sound a full alarm
2. In HOME, HOME 2 or DISARMED modes, sound
a low-volume warning sound.
Tamper deactivation will cause an alarm restore and
Doc ID. SG3PROG00103_03_2014.DOC 9