Event Log - Ness Security Products Securityguard III Programming Manual

re-arm for subsequent Tamper activations. The
Alarm log will clear only after an Arm/Disarm cycle,
whether or not Tamper deactivation has occurred.
PANIC < PANIC ALARM from key or fixed panic button or
medical key
KEY
(or BUTTON
On silencing a PANIC alarm (OFF button), the status
or MEDIC) <
display indicates which key caused the alarm.
1-23
Radio jamming signal detected.
RADIO <
JAMMED
RADIO < Radio intentional message substitution detected.
TAMPER

Event Log

Intruder alarm events are logged in memory and displayed with the time elapsed since the alarm
occurred.
In DISARMED mode, press OFF to step through the log. Once all logged alarms have been displayed,
pressing OFF will clear the display. Pressing OFF again will redisplay the first event in the log, etc.
To clear the log, enter ARMED, HOME or HOME 2 modes.
The alarm event log will store up to 5 events. If the log is full, logging a new event causes the oldest
event to be discarded. Events older than 100 days will be discarded.
Doc ID. SG3PROG00103_03_2014.DOC 10