Ness Security Products Securityguard III Programming Manual page 26

VOICE MESSAGES & OPTIONS
Voice annunciation can be independently enabled/disabled for each of the following categories. Note that there is no voice annunciation available in
PROGRAM mode.
Messages are annunciated at the programmed volume level. Messages are annunciated only when triggered by a user, either by pressing the OFF button, or
when the main PIR is triggered (once only, for a new message).
For details of "chirp" responses, and complete list of voice messages, see appropriate sections elsewhere in this document.
Category
1. Status (ARMED, DISARMED etc)
2. Alarm events
Doc ID. SG3PROG00103_03_2014.DOC
When
Entering ARMED mode:
Start of exit delay
End of exit delay
Entering HOME/HOME 2 mode:
Start of exit delay
End of exit delay
Disarming from ARMED mode
Disarming from HOME/HOME 2
mode
During alarm
Disarming system:
Sensor alarm
Key (Panic) alarm
Siren Tamper
Sensor Tamper
Chirp and/or Voice response
Voice Voice enabled
disabled
chirp "Armed"
chirp chirp
chirp "HOME [or HOME 2] armed", no external chirps even if
enabled
chirp chirp
chirp "Disarmed"
chirp
"Disarmed", no external chirps even if enabled
siren/chirp siren/chirp
chirp chirp, followed by
"Warning! Intruder may be present! Alarm from sensor two"
chirp chirp, followed by
"Warning! Panic alarm from key one"
chirp chirp, followed by
"Warning! Intruder may be present! Outside siren tamper.
Check siren"
chirp chirp, followed by
"Warning! Sensor two tamper. Check sensor two"
26