Ness Security Products Securityguard III Programming Manual page 7

DOORBELL
•
Fixed single button doorbell
•
Program option BELL
•
Not supervised
PANIC/DURESS OPERATION
Panic/duress alarms may be sent by either a
•
User Key PANIC button (button delay)
•
Fixed Panic Button (no button delay)
The panic alarm described above can be programmed as either:
•
Panic Alarm - Internal and external sirens sound immediately and the strobe flashes. Panic alarm
reported on dialler if fitted. Press OFF to silence
•
Duress Alarm - Panic alarm reported silently on dialler. Sirens and strobe are not activated
OK LIGHT
A visual indication of correct functioning of the unit shall be provided as a light on the front panel, with
the behaviour shown:
Mode
DISARMED, ARMED, HOME, HOME 2
modes
Battery charging from mains
Main PIR trigger
Reed switch Check mode programmed
FRONT PANEL PUSHBUTTONS
The font panel buttons allow the user to program the options shown below. Press the Left Button to
step through each option; press the Right Button to step through the various values for the selected
option (the last value selected becomes the new programmed value).
Selected options and values are annunciated as well as displayed. The display extinguishes after a
short period of inactivity.
VOLUME VOICE ANNUNCIATION & BEEP VOLUME (default = 3)
Volume level (1=quietest)
1-4
BELL DOORBELL SOUNDS (default = BELL 1)
"ding-dong"
BELL 1
"ding"
BELL 2
BELL 3 "fog horn"
BELVOL DOORBELL VOLUME (default = 3)
OFF Doorbell disabled
Volume level (1=quietest)
1-4
Doc ID. SG3PROG00103_03_2014.DOC
Behaviour
See section above for description
Inverse of behaviour above, i.e. light ON and flashes
OFF briefly (not PROGRAM mode). After 24 hour
charging period has expired, light reverts to normal
operation even if mains is still connected.
OK light turns on for a few seconds when PIR triggers
in:
1. PROGRAM mode when RANGE or PULSE
selected
2. DISARMED mode (after triggering in DISARM
mode, the main PIR is locked out for 4 minutes to
conserve the battery) similar to radio PIR's
OK light turns on when device is selected in
PROGRAM mode and is a reed switch programmed
in Check mode.
7