Monitor Level; Main Level - Peavey XR s Operating Manual

Front Panel
max min max min
high high
max min
min max
max
min max min
clip clip
max min max min
sig sig
max min max min
6 7
LEVEL LEVEL
FLS
40
When feedback occurs, the corresponding LED of the frequency that is closest to the frequency that is feeding back will illuminate over the
slider to be adjusted. Slowly bring the corresponding slider down until feedback is gone. The LED will remain illuminated for a few seconds
after the feedback is gone. If the feedback doesn't return, all of the LEDs will become active again, acting as a normal EQ.
GRAPHIC EQ
41
These nine-band Equalizers are designed to either be used to reduce feedback or to adjust the overall frequency response of the signal being
sent to the amplifiers. Subtle adjustments made with the graphic equalizer can improve the way your loudspeaker system sounds in the room.
You should be aware however, that setting large amounts of boost or arbitrary curves can reduce amplifier headroom, leading to early distor-
tion or just plain bad or unintelligible sound. Working with the FLS, the graphic EQ can also be used to reduce feedback. Each band of EQ can
supply up to 12dB of boost or cut.
LEVEL LED LADDER
42
These LEDs indicate the signal level of the main mix and the monitor mix. The top LED indicates LIMIT and activation of our revolutionary
DDT speaker protection circuit. Peavey's award winning speaker protection is built into the XRs powered mixer and is activated automatically
to maximize the power amplifier without fear of distortion.
KOSMOS-C
43
The Kosmos-C uses special circuitry to enrich the sound of your system. This is not just a simple bass boost. It provides "natural bass enhance-
ment" by adding harmonically related bass signals that track the envelope of the original signal. The amount of effect is greatly influenced by
the source material and some experimenting may be necessary to get the best results.
EFX TO MON
44
This switch toggles the EFX return signal being sent to the monitors. When it is lit, the effects signal is being sent to the monitors.

MONITOR LEVEL

45
The Monitor level control adjusts the level of the signal coming out of the Monitor send ¼" jack (15b). It can also be assigned to feed the 2nd
power amplifier via the selector switch (20) on top of the mixer.

MAIN LEVEL

46
The Main level control sets the level of the main mix and the overall volume of the powered mixer.
USB
IN
max
63
+12
min max
high
+6
40
0
-6
-12
MONITOR
max min max
41
63
+12
+6
min max
max
0
-6
-12
clip clip
MAIN
max min max
sig sig
max min max
min/o
8
LEVEL
Press to Select
MEDIA
USB MEDIA PLAYBACK
SELECT
125 250 500 1K 2K 4K
FLS FEEDBACK LOCATING SYSTEM
125 250 500 1K 2K 4K
FLS FEEDBACK LOCATING SYSTEM
EFX TO MON
min max
max
LEVEL LEVEL
43 44 45
10
EFX DEFEAT
MIC MUTE
SIGNAL
8K 12K
LIMIT
-6
-12
-18
-24
-30
42
SIGNAL
8K 12K
LIMIT
-6
-12
-18
-24
-30
min max
LEVEL
46