Panasonic KX-HDV100 Administrator's Manual page 22

1.1.3 Basic Network Setup
Configuring the Network Settings of the Unit
The following procedures explain how to change the network settings via the unit.
For details about the individual network settings that can be configured via the unit, refer to the Operating
Instructions on the Panasonic Web site (® see Introduction).
For details about configuring network settings via the Web user interface, see 4.3.1 Basic Network
Settings.
To configure IP Mode (IPv4, IPv6, IPv4&IPv6)
1.
2. [ ]/[ ]: "System Settings" ®
3. [ ]/[ ]: "Network Settings" ®
4. [ ]/[ ]: "IP Mode Select" ®
5. [ ]/[ ]: "IPv4" / "IPv6" / "IPv4&IPv6" ®
•
The initial value is "IPv4".
Configuring the Network Settings Using IPv4
To configure network settings automatically
1.
2. [ ]/[ ]: "System Settings" ®
3. [ ]/[ ]: "Network Settings" ®
[ ]/[ ]: "IPv4 Settings" ®
4.
5. [ ]/[ ]: "DHCP" ®
6. [ ]/[ ]: "Auto" ®
•
Select "Manual" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then press
To configure network settings manually
1.
2. [ ]/[ ]: "System Settings" ®
3. [ ]/[ ]: "Network Settings" ®
4. [ ]/[ ]: "IPv4 Settings" ®
5. [ ]/[ ]: "Static" ®
6.
Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary, DNS2
(secondary DNS server), and then press
Configuring the Network Settings Using IPv6
To configure network settings automatically using DHCP
1.
[ ]/[ ]: "System Settings" ®
2.
3. [ ]/[ ]: "Network Settings" ®
[ ]/[ ]: "IPv6 Settings" ®
4.
5. [ ]/[ ]: "DHCP" ®
22 Administrator Guide
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
.
OK
.
Document Version 2015-02