Fujitsu AS* A09LEC Service Instruction page 61

1-4. Setting the Indoor room temperature sensor switching function
(Only for Wired remote controller)
The following settings are needed when use the control by
Wired remote controller temperature sensor.
Setting Description
No
Yes
* If setting value is "00" : Room temperature is controlled by the indoor unit temperature sensor.
* If setting value is "01" : Room temperature is controlled by remote controller unit sensor.
1-5. Setting the Remote controller signal code
Change the indoor unit Signal Code, depending on the remote controllers.
Setting Description
A
B
C
D
(
Function Number Setting Value
42
(
Function Number Setting Value
44
03-02
Factory setting)
00
01
Factory setting)
00
01
02
03