Electrical Instructions - Philips 150P4CG Service Manual

15" tft lcd colour monitor
Hide thumbs Also See for 150P4CG:
Table of Contents

Advertisement

Available languages

Available languages

http://www.jdwxzlw.com/?fromuser=华盛维修
0. General
When carry-out the electrical settings in many cases a video
signal must be applied to the monitor. A computer with :
- ATI VGA 1024 V6-1.04/PH BETA4 interface card
- PGA 1024 (4822 212 30916), Mach 8.
- PGA 1280 (4822 212 30917), Mach 32.
- ATI GPT-1600 (4822 397 10065), Mach 64 (up to 107kHz)
are used as the video signal source. The signal patterns are
selected from the "service test software" package, see user
guide 4822 727
19896 (ATI1024), or 4822 727 20273 (PGA 1280), or
4822 727 21046 (GPT-1600).
0.1
With normal VGA card:
If not using the ATI card during repair or alignment, The service
engineer also can use this service test software adapting with
normal standard VGA adaptor and using standard VGA mode
640 x 480, 31.5 kHz/60 Hz (only) as signal source.
0.2
AC/DC Measurement:
The measurements for AC waveform and DC figure is based on
1024 x 768 48kHz/60 Hz resolution mode with test pattern "32
gray scale".
1.General points
1.1 During the test and measuring, supply a distortion free AC mains
voltage to the apparatus via an isolated transformer with low
internal resistance.
1.2 All measurements mentioned hereafter are carried out at a
normal mains voltage (90 - 132 VAC for USA version, 195 -264
VAC for EUROPEAN version, or 90 - 264 VAC for the model with
full range power supply, unless otherwise stated.)
1.3 All voltages are to be measurement or applied with respect to
ground, unless otherwise stated. Note: don't use heat-sink as
ground.
1.4 The test has to be done on a complete set including LCD panel in
a room with temperature of 25 +/- 5 degree C.
1.5 All values mentioned in these test instruction are only applicable
of a well aligned apparatus, with correct signal.
1.6 The letters symbols (B) and (S) placed behind the test instruction
denotes
(B): carried out 100% inspection at assembly line
(S): carried out test by sampling
1.7 The white balance (color temperature), has to be tested in
subdued lighted room.
1.8 Repetitive power on/off cycle are allowed except it should be
avoided within 6 sec.
2. Input signal
2.1 Signal type
Video : 0.7 Vp-p linear, positive polarity
Sync. : TTL level, separate, positive or negative polarity
Signal source: pattern generator format as attachment.
(table 1 to 14) Reference generator : CHROMA 2200 or 2250
2.2 Input signal mode
Pre-set 14 modes
家电维修资料网,免费下载各种维修资料

Electrical instructions

3. AC Adaptor
3.1Setup the AC I/P at 90VAC, and Output DC loading at 3.8 Amp,
The DC output voltage is 12 0.5 V DC
3.2Adjustment is nothing to do
4. Display Adjustment
4.1Input signals check
In factory mode, use 64 gray level and set the R,G,B sub gain to
100%.
4.2 Display quality test
Use timing mode as described in 2.2,2.3,2.4, and use the POPO
(pixel on pixel off) pattern to adjust the clock until no stripe and
adjust the phase until clear picture. Check all pre-setting 14
modes.
4.3 Check of WHITE-D (B)
control at 100%, and contrast control at 50%. Adjust the R, G, B
sub_gain, for the screen center, the 1931 CIE chromaticity (X, Y)
co-ordinates shall be;
Use Minolta CA-110 for color coordinates and luminance check.
Luminance; 250 Nits (Hannstar panel) in the center of the screen.
4.4 Check the digital interface
PRESET VIDEO RESOLUTION
Factory preset video resolution
Dot rate (MHz) H.freq (KHz)
Mode
25.175
31.469
IBM VGA 10h
28.322
31.469
IBM VGA 3h
25.175
31.469
IBM VGA 12h
30.240
35.000
MACINTOSH
31.500
37.861
VESA
31.500
37.500
VESA
36.000
35.156
VESA
40.000
37.879
VESA
50.000
48.077
VESA
49.500
46.875
VESA
57.300
49.700
MACINTOSH
65.000
48.363
VESA
75.000
56.476
VESA
78.750
60.023
VESA
Apply a 48kHz/60Hz signal with white pattern, set brightness
9300°K
x (center)
0.281 ± 0.005
y (center)
0.311 ±
0.005
Set the delay time to be 6 nsec.
Check the 64 gray level color poor & noise condition.
150P4 LCD
19
Go to cover page
Resolution
V.freq (Hz)
640 * 350
70.087
720 * 400
70.087
640 * 480
59.940
640 * 480
66.667
640 * 480
72.809
640 * 480
75.000
800 * 600
56.250
800 * 600
60.317
800 * 600
72.188
800 * 600
75.000
832 * 624
75.000
1024 * 768
60.004
1024 * 768
70.069
1024 * 768
75.029
6500°K
0.312 ±
0.005
0.338 ±
0.005

Advertisement

Table of Contents
loading

Table of Contents